Model:LY-400S Power supply: 220V/50Hz Vacuum pump power: 0.75KW Vacuum chamber size: 400X360X70mm Sealing size: 400mm Pumping speed: 20m3/h Outline dimension: 1000X680X900mm Weight of the whole machine: 140kg
characteristic 1, the machine has a very effective smoke elimination performance, do not need to take over the exhaust 2, the use of the machine and to facilitate. Under pressure from the machine cover, vacuum pumping, heating, cooling, sealing, printing label to cover gas machine, automatic control 3, sealing temperature and sealing time is very wide, suitable for a variety of different materials packaging 4, the machine is equipped with emergency stop button, such as the discovery of the abnormal packing process, press and hold the emergency stop button, you can interrupt the packaging process, rapid exhaust, open the machine cover
Operation steps 1. Connect the power: machine, vacuum pump power and heating power with machine size is not the same, please choose corresponding line and wiring (because the general ordinary socket is unbearable, so our factory is not connected to the plug, require buyers back according to their own site actual power with plug and wiring at 2. Check the vacuum pump oil level: to open the side of the cover, can be seen on the side of the bottom of the machine vacuum pump has a transparent semi glass ball, through the transparent glass half sphere (also called observation glass hole) are able to see the inside of the vacuum oil, vacuum oil level to to observe the position of the glass hole 2 / 3 to prevail, but also cannot too full, not more than 3 / 4 of the glass hole position observation and vacuum oil use in the future should be changed frequently 3 set working time data: set according to the material and thickness of vacuum bag sealing voltage (typically 2 files) cooling time (generally 2.5 seconds) and heat sealing time (generally between 1.5 to 2.5 seconds, not more than 2.5 seconds, pay special attention to this: heat sealing time is not a special case not more than 2.5 seconds, do not exceed 3 seconds), then according to the required type of vacuum packaging of goods and the vacuum packaging requirements to set the vacuum time (usually between 5-50 seconds) 4 turn on the power switch to see if the power indicator light is on, and if it is not on time to check the reason, the power indicator light quantity to carry out the following work; 5 enter the vacuum sealing procedure: open the vacuum chamber cover, will be ready to install vacuum bag to pack goods flat on the double room on both sides of a vacuum chamber sealing strip (also can only put aside), and use the bag layering pressed flat pressure stability, and then use the double hand steady cover on the vacuum cover (slightly, with the vacuum cover is sucked, so far) machines have started to work (which can be placed on the other side of the vacuum chamber packaging preparation) vacuum, sealing and printing (printing can not some products without this feature), cooling one automatically, after the completion of automatic bounce vacuum cover, then the vacuum chamber lid moved to the other side of vacuum chamber just ready packaging, steady pressure under the lid again, this cycle could have been; 6 shells open cover the whole process of the vacuum packaging is completed, a perfect vacuum packaging products will appear in front of you, you only need to be careful to take him out of the vacuum chamber! Then go on to the next package!